without folding or routing
Install faster while reducing costs and tools.
Get Free Quote
In a typical ACM panel system, edges are routed and then bent to form a return to secure the panel onto the attachment. Cladiators is an attachment panel system for the architectural wall cladding industry, which allows the installation of panels without routing or bending.
By having no folds, Cladiators is able to maximize the use of the ACM sheet, which means that more panels can be produced from raw material sheets because the entire panel is used.
Cladiators is easy to customize and install; just cut the panel to the proper size and slide into place. Panels are held in place by friction, eliminating screws, rivets or caulking. It does not need to be pre-fabricated or customized prior to delivery.
Get Free Quote
No routing or bending panels to create returns for the attachments.
Cladiators maximize the use of the ACM sheet, reducing waste and cost.
Cladiators in a Nutshell
Order with a
Minimum Lead Time
Since the Cladiators flat panel systems do not require returns, it does not need to be pre-fabricated or customized prior to delivery.
Full Sheet: 196” x 62”
Half Sheet: 98” x 62”
Need to trim a panel to fit? Measure, cut, and install in the field. On-site customization is easier with Cladiators because no routing is required. Simply trim off any extra material from the panel and slide it into the Cladiators attachment system for a perfect fit.
Do It Yourself. To save even more money and time, purchase full ACM sheets and do the custom panel cutting yourself.
Build The Grid | Easy & Fast Installation
Install Cladiators attachments. Cut the panel to the proper size and slide into place. Panels are held in place by friction, eliminating screws, rivets or caulking. Cladiators offers a faster installation with less tools.
Starter Attachment is installed, plumb to the wall and levelled horizontally.
A second Starter Attachment is installed, plumb to the wall and levelled vertically.
Install the Stiffener Base and the Stiffener Slide along with 3M VHB Tape for large panel sizes.
Slide the ACM sheet without routes or bends.
Slide the ACM panel into the Starter Attachment Slot until it is flush against the inside of the Attachment Slot. The panel is now held in place on the bottom and the left edges.
A Base Attachment is fit onto the right edge of the existing panel until the ACM panel is flush against the Attachment Slot.
Slide the ACM panel into the Starter Attachment Slot until it is flush against the inside
A Base Attachment is fit onto the right edge of the existing panel until
Repeat Steps 4-5 until the entire wall is covered in ACM panels that are secured on all 4 sides